2025/2026 SDI FIREARMS INSPECTION AND TROUBLESHOOTING (FTT 111) ACTUAL Q&A 100% PASS

Inside The Document

2025/2026 SDI FIREARMS INSPECTION AND TROUBLESHOOTING (FTT 111) ACTUAL Q&A 100% PASS Which of the following statements are not true about safety and ammunition? - Answer -Always keep ammunition in the gunsmithing area It is required to both __________________ and _____________________ once the action is open to ensure the weapon is safe. - Answer -Visually Check; Physically Check The initial function check is to be done: - Answer -With no rounds or snap caps Some break-action firearms are cocked when the __________ acts upon the _____________________ and cocks the _________________. - Answer -Lug; Cocking Lever; Hammer T/F: Manual Actions require the operator to use a moderate to heavy force to close the breach. - Answer -FALSE Revolvers will lock at about the same time when the ____________ is in its ______________ position. - Answer -Hammer; Cocked Which of the following firearm types "push" the extracted round from the chamber? - Answer -Break Action T/F: With a fixed ejector, you must quickly manipulate the action to Need assistance on Online classes, Exams & Assignments? Reach out for instant help!! Full Course Assistance, Plagiarism-free Essay Writing, Research Paper, Dissertation, Discussion Posts, etc…. Confidential & Secure services. Tutors are available for all subjects! Email now at: tutorjean01@gmail.com ensure the round is properly ejected. - Answer -TRUE Snap caps are meant to identify which of the following malfunctions? - Answer -Failures to Extract, Eject, and Feed Which of the following contribute to a failure to feed? - Answer -Feeding Device; Action Parts; Ammunition Match the numbered step of the fire control group with its description: - Answer -1) With snap caps in the chamber, set the safety in the "safe" position. 2) Depress the trigger; it will not move. 3) Release the trigger and move to "fire" position. 4) Depress the trigger again; hammer will have audible "click" 5) Continue to depress trigger, manually cycle the action and eject the snap cap. 6) Release trigger, click and hammer should not move. 7) Use a nylon or rubber hammer and tap the receiver or action. 8) Set safety to "safe" position, nothing should happen. T/F: When a firearm equipped with a decocker is in the "safe" position, the hammer may fall. - Answer -TRUE What would be the purpose to tap a pistol's external hammer with a rubber mallet? - Answer -To check the hammer/sear engagement Match the type of cartridge to its proper headspace location: - Answer -Rimfire-Rim of the case; Belted Magnum Cartridge- Top of the belt of the case; Centerfire Pistol Cartridge- Leading edge to the mouth; Bottleneck Centerfire Rifle Cartridge-Datum line or near center of shoulder. T/F: Too little headspace can result in the case expanding too much, which may lead to an explosion in the chamber. - Answer -FALSE What happens when you headspace a cartridge with the extractor installed? - Answer -The measurement is reading off the extractor instead of the breech face. Need assistance on Online classes, Exams & Assignments? Reach out for instant help!! Full Course Assistance, Plagiarism-free Essay Writing, Research Paper, Dissertation, Discussion Posts, etc…. Confidential & Secure services. Tutors are available for all subjects! Email now at: tutorjean01@gmail.com